- Home
- Catalog
- Antenna switches
- Antenna 4 to 1 switch up to 1500 W (WI-FI interface)
- Antenna 4 to 1 switch up to 1500 W hamradio HF (1-54MHz)
- DIY KIT for Antenna 4 to 1 switch up to 1500 W
- DIY KIT for Antenna 8 to 1 switch up to 1500W
- HF Power Splitter (2 ports)
- RX antenna switch 4 to 1 with preamplifier 15dB
- RX Audite – SDR splitter/switch
- Band Decoders and converters
- Band decoder for Xiegu and Lab599
- Converter Icom (Xiegu) band voltage to Yaesu ABCD banddata
- Converter Yaesu ABCD BandData to ICOM band voltage
- Converter Yaesu BCD to Icom CI-V band data
- ICOM CI-V Band Decoder (10 outputs)
- Kenwood CAT Band Decoder (10 outputs)
- RF sampling Automatic Band Decoder 1-30 MHz
- Universal Band Decoder (Kenwood CAT protocol)
- Yaesu ABCD Band Decoder (10 outputs)
- Yaesu ABCD BandData splitter 4 outputs
- Control consoles
- Other devices
- Bias Tee
- CAT interface for Icoms and Xiegu
- Dummy Load RF 50 Ohm (SO-239)
- GPS-based scheduler
- High Voltage Step UP DC-DC module
- nanoKeyer (based on K3NG Arduino keyer)
- PTT splitter 1 to 4
- PTT switch with RF detect
- QRM Eliminator X-Phase
- RF Relay Sequencer 4 ports/3 events
- RF Sampler Modulation monitor 1-50 MHz
- RX/TX antenna switch
- SWR and Power meter with Wi-Fi interface 1-30 MHz
- Thermometer and Thermorelay with WI-FI interface
- Receive antennas
- Antenna splitter 4 ports for RX antenna
- Antenna splitter RX (1-50 MHz, BNC)
- Beverage Antenna RF Isolating transformer 50/450 Ohm
- K9AY receiving loop with Wi-Fi control
- Push-pull HF pre-amplifier (Gain 15dB)
- Receive Feedline Common Mode Сhoke (feedthrough DC, SO-239)
- WellGood Loop Active HF Antenna 1-30MHz
- YCCC Hi-Z preamplifier box
- Antenna switches
- Contact Us
- Downloads
- Payment
- Shipping information
Hello Anton I tried to install the Kenwood band decoder today. The driver is installed and where can I find the files to connect to the TS590SG?
Hello Wolfgang. You need to connect this band decoder to TS590SG via RS232 cable. Don’t forget to set 9600 kb/s for CAT system in your transceiver menu.